Linear DVS-1200 User Manual download pdf (Page 40)

COMMUNICATOR REPORTING CODES

✦ The 4 by 2 two-digit communicator reporting code

for each event has a factory set value. These values

may be customized to ﬁ t the speciﬁ c installation and

the reporting requirements of the Central Station

monitoring the system.

✦ If Point ID reporting is enabled (the factory default

setting), each sensor can report a unique alarm and

trouble code.

✦ If Point ID is disabled, the “general” reporting codes

for each event type will be used.

✦ Each programming function is performed with

similar keystrokes. After the system is in Setup

Mode, enter the programming step number and

press HOME, then enter the new value and press

AWAY. For reference, follow the ﬁ gures next to the

programming steps.

✴ If the new value is accepted, a “Bing” will sound. If the new

value is not accepted, a “Double Buzz” will sound.

✦ Making a value 0 causes the event not to

communicate to the Central Station.

✎ NOTE: The reporting codes are ﬁ xed for opening

and closing. A unique code is reserved for the

master and the ﬁ ve restricted user codes. See the

Opening & Closing Reporting Codes Table.

GENERAL REPORTING CODES

✦ Use program Steps #201 - 206 to change the

communicator reporting codes when Point ID is

disabled.

✦ Refer to the General Reporting Codes table to view/

edit the reporting codes for each of the ﬁ ve events.

The factory settings are listed, along with a blank

area to write in the new installation values.

STEPS #201-206

Any value from 0-99 can be programmed for each

event using these steps (enter “0” to stop an event

from reporting).

✎ NOTE: Be careful not to duplicate codes unless the

Central Station requires speciﬁ c codes for certain

types of events.

General Reporting Codes Table

GENERAL REPORTING CODES

STEP # PROGRAMMING FUNCTION POSSIBLE 4 BY 2 VALUES FACTORY 4 BY 2 VALUES INSTALLATION 4 BY 2 VALUE

201 GENERAL FIRE REPORT CODE 0 - 99 1

202 GENERAL EMERGENCY REPORT CODE 0 - 99 2

203 GENERAL SILENT PANIC REPORT CODE 0 - 99 3

204 GENERAL BURGLARY REPORT CODE 0 - 99 4

206 GENERAL TROUBLE REPORT CODE 0 - 99 6

ADEMCO REPORTING CODES

EVENT ALARM CODE EXTENDED CODE

SENSOR EMERGENCY E120 C0xx

CONSOLE EMERGENCY E120 C026

SENSOR FIRE E111 C0xx

CONSOLE FIRE E110 C025

BURGLARY ALARM E130 C0xx

SILENT PANIC E122 C0xx

FORCE ARM E574 C000

DURESS E121 C000

CANCEL E406 C000

SENSOR LOW BATTERY E384 C0xx

SENSOR STATUS TROUBLE E381 C0xx

CONSOLE LOW BATTERY E302 C000

CONSOLE BATTERY RESTORE R302 C000

2-WAY AUDIO E606 C000

xx = SENSOR NUMBER IN EXTENDED REPORT

HOME

TEST

= PROGRAM

= REMOVE

AWAY

= STORE

0 - 99 FOR GENERAL

ALARM REPORTING CODE

PROGRAMMING STEPS

#201 TO #206

PROGRAM

STORE PROGRAM

ABC

1 2 ... 35 36 37 38 39 40 41 42 43 44

Comments to this Manuals

No comments

Linear DVS-1200 User Manual Page 40

Comments to this Manuals

Related products and manuals for Safety Linear DVS-1200