Linear DVS-1200 User Manual download pdf (Page 14)

✦ In a new installation, when power is ﬁ rst applied

the system's master user code is “1234”.

CREATE THE MASTER USER CODE

✎ NOTE: Local programming must be entered on

the Console's keypad, not on a wireless remote

keypad.

1. Press

(clears keypad if any other keys have

been pressed).

2. Place the Console in Test Mode (enter 1234 and

press TEST.

✴ A “gong” and four “beeps” will sound.

3. Enter the Setup Mode from Test Mode, enter 1234

then press TEST again.

✴ A “gong” and ﬁ ve “beeps” will sound. The system is now in

Test Mode.

4. Enter 99 then press HOME.

5. Enter any combination of 1-5 digits for the master

user code, then press AWAY.

✎ NOTE: For maximum security, a three to ﬁ ve digit

code is recommended.

6. Press and hold the OFF key for 3 seconds to exit

program mode.

7. Test the new master user code by entering it then

pressing TEST.

8. Log the master user code in the box below.

✎ NOTE: The master user code can be used to enter

Setup Mode. The restricted user codes cannot. To

create restricted user codes, see the “Advanced

Programming” section of this manual.

PROGRAM THE SENSORS INTO THE CONSOLE’S MEMORY

✦ Each wireless sensor that is going to be used

with the Console must be programmed into the

Console’s memory.

1. Start with the Console in Test Mode (enter any user

code and press TEST).

2. Enter the Setup Mode from Test Mode, enter the

master user code then press TEST again.

✴ A “Gong” and ﬁ ve “Beeps” will sound.

✴ The sensor status indicators will light for any sensors

programmed into the Console.

3. Enter an unused sensor number from 01-12 (you

must enter two digits, example: 5 = 05).

✴ The sensor indicator light will ﬂ ash for the sensor number

selected.

4. Activate the sensor by sending a test or alarm

signal (be sure the sensor's battery is connected or

that its battery protection strip is removed).

✴ A single “Bing” tone will sound and the sensor status

indicator for that sensor will stay lit.

5. Enter another sensor number or exit Setup Mode by

pressing the OFF key for three seconds.

START IN OFF

DEFAULT

MASTER

USER

CODE

1 GONG &

4 BEEPS

(TEST MODE)

START IN SETUP

PROGRAMMING

STEP #99

NEW

MASTER

USER

CODE

DONE

HOLD FOR

3 SECONDS

TO EXIT

SETUP

STORE

CODE

ENTERING

SETUP

MODE

CLEARS

KEYPAD

DEFAULT

MASTER

USER

CODE

1 GONG &

5 BEEPS

(SETUP MODE)

SETTING A

NEW MASTER

USER CODE

PROGRAM

START IN TEST

MASTER

USER

CODE

1 GONG &

5 BEEPS

NEW

SENSOR

NUMBER

ACTIVATE

SENSOR

DONE

TEST

6. BASIC CONSOLE PROGRAMMING

MASTER USER CODE:

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Comments to this Manuals

No comments

Linear DVS-1200 User Manual Page 14

Comments to this Manuals

Related products and manuals for Safety Linear DVS-1200