Linear DVS-1200 User Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
14
Each accessory sensor is packaged with its own
set of installation instructions specifi c to the model
of sensor.
Refer to the sensor's instructions for details on
installing, operating, and testing of the sensor.
Following are basic instructions for installing two
popular DVS-1200 accessories: The Model DXS-10
Wireless Remote Keypad and the Model DXS-31 or
DXS-32 Door/Window Transmitters.
DXS-10 WIRELESS KEYPAD
The DXS-10 is used to remotely command the
Console.
The keypad can be simply set on a table or
mounted to a fl at surface.
TABLE-TOP USE
Four anti-mar pads are provided as a scratch
deterrent “feet” for the keypad.
NOTE: Do not use the adhesive “feet” if the keypad
is going to be wall mounted.
1. Peel off the adhesive tape backing on the pads and
stick them to the back of the keypad.
The wireless keypad can be used as a portable
keypad. Because of the hourly supervisory
transmissions, if the unit is taken out of range from
the Console for more than eight hours, the Console
will indicate “radio trouble” for the keypad. The
keypad's sensor number can be programmed for
“non-supervised” if required. See the “Advanced
Programming” section of this manual.
WALL MOUNT USE
The wireless keypad can be wall mounted in a
convenient location.
1. Open the keypad by inserting a small screwdriver in
one of the top slots in the keypad case. Gently twist
the screwdriver until the case pops open.
2. Attach the rear case to the wall using the two
screws provided.
NOTE: For best signal transmission, the keypad
should be mounted at least three feet above
ground level.
3. Hook the top edge of the keypad case together and
snap the keypad onto the rear case.
WARNING: The wireless keypad is designed for
indoor use only.
7. BASIC SENSOR INSTALLATION
FROM TOP OF CASE TWIST
SCREWDRIVER BETWEEN
CASE HALVES UNTIL IT
POPS OPEN
CONNECT BATTERY
TO BATTERY CLIPS
USE THE FOUR SCRATCH
DETERRENT PADS PROVIDED
FOR TABLE-TOP USE
ATTACH REAR CASE TO WALL
WITH THE TWO SCREWS PROVIDED
MOUNT AT A CONVENIENT
LOCATION NEAR PRIMARY
ENTRY/EXIT DOOR
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Comments to this Manuals

No comments