Linear DVS-1200 User Manual download pdf (Page 22)

TEST MODE

✦ Even though this is a self-monitoring supervised

system, the National Burglar and Fire Alarm

Association recommends that all security systems

should be tested manually on a regular basis.

1. The Console must be in Off Mode before switching

to Test Mode.

2. Switch the Console into Test Mode by entering a

user code and pressing TEST.

✴ When the system is switched to the Test Mode, the Console

will sound a “Gong” and four “Beeps”.

3. Holding down the TEST button in Test Mode will light

all of the Console’s indicators.

✴ The sensor status indicators will ﬂ ash for each sensor

programmed into the Console.

4. Go to each sensor and press its test button or open

and close the protected opening.

5. To test the wireless keypad, press the wireless

keypad’s

key.

✴ The Console will make a “Bing” sound as each sensor is

tested, followed by 1-3 beeps indicating signal strength with

3 beeps being the strongest signal.

✴ As each sensor is tested, the sensor status indicator for the

sensor will stop ﬂ ashing and return to showing the current

status of the sensor.

6. Continue testing until there are no ﬂ ashing sensor

status indicators.

SENSOR OPERATION IN EACH CONSOLE MODE

SENSOR TYPE OFF MODE CHIME MODE HOME MODE AWAY MODE

AUTOMATION ACTIVATES AND DEACTIVATES THE AUTOMATION OUTPUT

EMERGENCY ARMED 24-HOURS - TRIGGERS EMERGENCY ALARM

PANIC ARMED 24-HOURS - TRIGGERS SILENT PANIC ALARM

FIRE ARMED 24-HOURS - TRIGGERS FIRE ALARM

PERIMETER DEACTIVATED CHIME INSTANT BURGLARY ALARM

EXIT/ENTRY DEACTIVATED CHIME DELAYED BURGLARY ALARM

INTERIOR DEACTIVATED DEACTIVATED DEACTIVATED

INSTANT BURGLARY ALARM UNLESS

ACTIVATED DURING AN ENTRY

DELAY, THEN IT IS DELAYED

CHIME CHIME

2-BUTTON ARM/DISARM (LEFT)

2-BUTTON AUTOMATION (RIGHT)

EMERGENCY (BOTH BUTTONS)

LEFT BUTTON SWITCHES SYSTEM TO AWAY MODE †

IF ALARM MEMORY IS ACTIVE, SWITCHES SYSTEM TO OFF MODE ‡

LEFT BUTTON SWITCHES SYSTEM TO OFF MODE ‡

2-BUTTON ARM (LEFT)

2-BUTTON DISARM (RIGHT)

EMERGENCY (BOTH BUTTONS)

LEFT BUTTON SWITCHES SYSTEM TO AWAY MODE †

IF ALARM MEMORY IS ACTIVE, SWITCHES SYSTEM TO OFF MODE ‡

RIGHT BUTTON SWITCHES SYSTEM TO OFF MODE ‡

ENVIRONMENTAL ARMED 24-HOURS - TRIGGERS ANNUNCIATION ONLY

INTERIOR HOME DEACTIVATED DEACTIVATED INSTANT BURGLARY ALARM

✎ NOTE: If the Console is left unattended in Test

Mode, it will automatically switch back to Off Mode

after three minutes.

✦ When directly connecting (without a telephone

line) to the DVS-1200 with the RA-2400 remote

access software (Version 1.3 or later), press the

EMERGENCY key while in Test Mode to cause the

Console to connect to the modem.

† CAN BE HOME MODE USING PROGRAMMING STEP 50

‡ CAN BE CHIME MODE USING PROGRAMMING STEP 51

Console Zone Table

START IN OFF

YOUR

USER

CODE

DONE

1 GONG

& 4 BEEPS

(OPTIONAL)

TEST MODE

TEST

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 43 44

Comments to this Manuals

No comments

Linear DVS-1200 User Manual Page 22

Comments to this Manuals

Related products and manuals for Safety Linear DVS-1200