Linear AE-100 User Manual download pdf (Page 23)

AUDIO PROMPTS FOR EACH PROGRAMMING METHOD

CONDITION

ALTERNATE

METHOD

SOUND

STANDARD

METHOD

SOUND

AFTER AN INCORRECT ENTRY

TWO

LONG

BEEPS

ONE

LONG

BEEP

AFTER A CORRECT ENTRY OF AN

INTERIM STEP

ONE

SHORT

BEEP

TWO

SHORT

BEEPS

AFTER A COMPLETE COMMAND

HAS BEEN ENTERED CORRECTLY

TWO

SHORT

BEEPS

THREE

SHORT

BEEPS

EXITING PROGRAMMING MODE

THREE

SHORT

BEEPS

SOUND

Q Z - , . ' *

q z 0 1 2 3

4 5 6 7 8 9

A B C a b c

D E F d e f

space

G H I h g i

P R S p r s

M N O m n o

W X Y w x y

J K L j k l

T U V t u v

erase

entire entry

move to

next letter

or finish

ALTERNATE INTERFACE KEYPAD ALPHANUMERIC ENTRY

(FOR PROGRAMMING STEPS REQUIRING TEXT)

• ENTER # AFTER EACH LETTER TO MOVE TO THE NEXT CHARACTER

• FINISH COMPLETE ENTRY BY ENTERING ##

• PRESS 8 THEN 0 TO BACKSPACE

• PRESS STAR TO ERASE ENTIRE ENTRY

ALTERNATE PROGRAMMING METHOD

PRESS TOGETHERAND

FOR

Alternate Programming Section

To make it easy for installers familiar with Linear’s and other manufacturer’s

access control systems, two methods of programming are available.

Function Codes that match other equipment help the installer to make

quick programming changes with keystrokes they have used before.

Alternate Programming Method Selection

The Programming Position Numbers (or Function Codes) change

depending on the programming method used. Refer to the table on

Page 13 for the numbers used for each programming method.

The keys used to enter programming from the unit’s keypad select

which programming method is used for the current programming

session.

Entering programming by pressing

keys together will select

the Alternate Programming Method (other manufacturer’s style). Details

of each programming step when using the Alternate Programming

Method are shown on Pages 23-31.

Alternate Audio Prompts

The audio prompts that give feedback during programming at the unit’s

keypad or over the telephone are different for the Alternate Programming

Method. Those differences are shown in the table to the right.

Alternate Alphanumeric Entry

When the keypad is used for alphanumeric data entry in the alternate

programming mode, each key enters data differently than the standard

interface mode. See the keypad ﬁ gure to the right.

Alternate Programming Access from the Keypad

1. Press

keys at the same time, then release.

2. The display will show [Master Code:].

3. Enter the master code (factory setting is 123456).

4. The display will show asterisks as the code is entered.

5. If the master code is incorrect, the system will sound two

long beeps and return to normal operating mode.

6. If the password is correct, the display will

show [SELECT FUNCTION:].

7. Programming commands can now be entered on the

keypad. Refer to the following pages in this manual

for Alternate Programming Method step details.

Re-entering a Command After a Mistake

If an incorrect entry, or an incorrect key is pressed during programming, to

clear the keypad press

and start the programming step over again.

Exiting Alternate Programming Mode

1. Press:

✦ NOTE: The AE-100 will automatically exit Programming Mode after

ﬁ ve minutes of programming inactivity.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Comments to this Manuals

No comments

Linear AE-100 User Manual Page 23

Comments to this Manuals

Related products and manuals for Door intercom systems Linear AE-100