Linear AE-100 User Manual download pdf (Page 30)

A U T O - A N S W E R = 1 :

E N A = 1 D I S A = 0 :

B E E P O N = 1 O F F = 0

U N L O C K B E E P ( 1 , 0 )

ALTERNATE PROGRAMMING METHOD

FUNCTION CODE LOCAL PROGRAMMING TELEPHONE PROGRAMMING

AUTOMATIC

TELEPHONE

ANSWER

The factory setting will allow the

system to detect a ring signal on

the telephone line and answer

the call.

NOTE: The automatic answer

feature can be turned off,

although remote programming,

remote access control by

residents, and resident call-back

features will no longer function

Step 1 Enter Function Code 74, then press #.

Step 2 The display will show the auto answer setting.

Enter 0 to disable auto answer.

Enter 1 to enable auto answer (default).

Step 3 Press #.

NOT AVAILABLE

SPEAKER CHIRP

ON KEYSTROKES

The factory setting will cause

the speaker to chirp when each

key on the keypad is pressed.

Alternately, the speaker chirp can

be turned off.

Step 1 Enter Function Code 75, then press #.

Step 2 Enter 0 to turn the keystroke chirps OFF.

Enter 1 to turn the keystroke chirps ON (default).

Step 3 Press #.

Step 1 Enter Function Code 75 and

press #, one short beep sounds.

Step 2 Enter 0 to turn the keystroke chirps OFF.

Enter 1 to turn the keystroke chirps ON.

Step 3 Press #, two short beeps sound.

SPEAKER TONE

ON ACCESS RELAY

ACTIVATION

The factory setting will cause the

speaker to sound a tone for two

seconds when the access relay

is activated. Alternately, the tone

can be turned off.

Step 1 Enter Function Code 76, then press #.

Step 2 Enter 0 to turn the relay tone OFF.

Enter 1 to turn the relay tone ON (default).

Step 3 Press #.

Step 1 Enter Function Code 76 and

press #, one short beep sounds.

Step 2 Enter 0 to turn the relay tone OFF.

Enter 1 to turn the relay tone ON.

Step 3 Press #, two short beeps sound.

RESIDENT

CONTROL OF

ACCESS RELAY

The factory setting allows the

resident to activate the access

relay by pressing the 9 key on

their telephone when a call from

the AE-100 is received. This

feature can be disabled. Disabling

this feature will only allow access

by using resident Access Codes

and Stand-alone Access Codes

at the unit’s keypad.

Step 1 Enter Function Code 77, then press #.

Step 2 Enter 0 to disable resident control of the access

relay.

Enter 1 to enable resident control

of the access relay (default).

Step 3 Press #.

NOT AVAILABLE

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

Linear AE-100 User Manual Page 30

Comments to this Manuals

Related products and manuals for Door intercom systems Linear AE-100