Linear AE-100 User Manual download pdf (Page 31)

31

E N T E R F U N C T I O N :

T E N A N T C A L L B K = 0

ALTERNATE PROGRAMMING METHOD

FUNCTION CODE LOCAL PROGRAMMING TELEPHONE PROGRAMMING

91

EXIT

PROGRAMMING

MODE

Entering this command number

will cause the unit to exit

programming mode and return to

normal operation.

Step 1 To exit programming mode, enter

Function Code 91, then press #.

NOTE: The AE-100 will automatically exit Programming

Mode after ﬁ ve minutes of programming inactivity

Step 1 To exit programming mode,

enter Function Code 91.

Step 2 Press #, three short beeps sound.

93

DELETE ALL

STAND-ALONE

ENTRY CODES

This utility command will

permanently erase all

Stand-alone Access Codes.

CAUTION: This utility

command will erase ALL the

Stand-alone Access Codes in

the unit.

Step 1 Enter Function Code 93, then press #.

Step 2 Enter the Function Code 93 again

for veriﬁ cation, then press #.

NOT AVAILABLE

95

TENANT

CALL-BACK

The tenant call-back feature

allows the AE-100 to answer

the telephone and switch to

speakerphone mode if the

telephone call is within 60

seconds of the last use of the

AE-100. This feature gives

residents the capability to

call a visitor back in case of a

recently missed call. The factory

setting has this feature disabled.

Alternately, this feature can be

enabled.

NOTE: The Automatic Telephone

Answer feature (Function Code

#74) must also be enabled for this

feature to function.

Step 1 Enter Function Code 95, then press #.

Step 2 The display will show the current setting.

Enter 0 to disable tenant call-back (default).

Enter 1 to enable tenant call-back.

Step 3 Press #.

NOTE: This feature can only be used in

single unit installations.

Step 1 Enter Function Code 95 and

press #, one short beep sounds.

Step 2 Enter 0 to disable tenant call-back.

Enter 1 to enable tenant call-back

Step 3 Press #, two short beeps sound.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments