Linear AE-100 User Manual download pdf (Page 20)

PPN 64

64#TIME#

TIME = TIME UNTIL AUTO-DISCONNECT

(010-180 SECONDS)

MAXIMUM VISITOR TALK TIME

FACTORY SETTING: 60 SECONDS

PPN 63

63#TONE#

TONE = 0 FOR ACCESS RELAY TONE OFF

TONE = 1 FOR ACCESS RELAY TONE ON

SPEAKER TONE ON ACCESS RELAY ACTIVATION

FACTORY SETTING: RELAY TONE ON

PPN 77

77#CONTROL#

CONTROL = 0 TO DISABLE RESIDENT CONTROL

CONTROL = 1 TO ENABLE RESIDENT CONTROL

RESIDENT CONTROL OF ACCESS RELAY

FACTORY SETTING: RESIDENT CONTROL ENABLED

PPN 95

95#CALL-BACK#

CALL-BACK = 0 TO DISABLE RESIDENT CALL-BACK

CALL-BACK = 1 TO ENABLE RESIDENT CALL-BACK

RESIDENT CALL-BACK

FACTORY SETTING: RESIDENT CALL-BACK DISABLED

STANDARD PROGRAMMING METHOD

System Options (Continued)

Speaker Tone on Access Relay Activation

The factory setting will cause the speaker to sound a tone for two seconds

when the access relay is activated. Alternately, the tone can be turned

off.

1. Press

2. Select the option for access relay activation tone:

Enter 0 to turn OFF the access relay activation tone.•

Enter 1 to turn ON the access relay activation tone.•

3. Press

Maximum Visitor Talk Time

Visitors will converse with residents over the telephone until the resident

grants or denies access. If the resident responds to the visitor’s request

by pressing their telephone key, the system will hang up and release

the telephone line. If for some reason the resident does not press

the telephone key or does not hang up, the system will automatically

disconnect the visitor after 60 seconds.

At ten and ﬁ ve seconds before the disconnect, a tone will sound on the

telephone to remind the resident of the pending disconnect. The resident

can extend the talk time by pressing the # key on their telephone. The

disconnect time can be adjusted from 10-180 seconds.

1. Press

2. Enter the disconnect time in seconds (010-180):

3. Press

Resident Control of Access Relay

The factory setting allows the resident to activate the access relay by

pressing the 9 key on their telephone when a call from the AE-100 is

received. This feature can be disabled. Disabling this feature will only

allow access by using resident Entry Codes and Stand-alone Entry

Codes at the unit’s keypad.

1. Press

2. Select the option for resident access relay control:

Enter 0 to turn OFF resident access relay control.•

Enter 1 to turn ON resident access relay control.•

3. Press

Resident Call-back

The resident call-back feature allows the AE-100 to answer the telephone

and switch to speakerphone mode if the telephone call is within

60 seconds of the last use of the AE-100. This feature gives residents the

capability to call a visitor back in case of a recently missed call.

This feature can only be used in single unit installations.

The factory setting disables the resident call-back feature. Alternately,

this feature can be enabled.

✦ NOTE: The Automatic Telephone Answer feature (PPN #61) must also be

enabled for the resident call-back feature to function.

1. Press

2. Select the option for resident call-back:

Enter 0 to turn OFF the resident call-back feature.•

Enter 1 to turn ON the resident call-back feature.•

3. Press

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Comments to this Manuals

No comments

Linear AE-100 User Manual Page 20

Comments to this Manuals

Related products and manuals for Door intercom systems Linear AE-100