Linear SLC User Manual download pdf (Page 18)

SLR • SLC • SLD Slide Gate Operator Installation Guide - 16 - 227968 Revision X19 8-11-2011

Advanced Controller Programming (Cont.)

Soft Start/Stop Duration

This function is only used with DC slide gate Model SLD. This

function causes the operator to start and stop the DC motor slowly

reducing gate wear and tear (at the full open or closed positions only).

The factory default sets the Soft Start/Stop Duration to 3 seconds. The

Soft Start/Stop Duration can be set from 1 to 10 seconds.

✓ NOTE: Changing the Soft Start/Stop Duration will reset the open and

close current setting value to zero. It will be necessary to reprogram

maximum open and close current settings.

✓ NOTE: This function will only be displayed in Model SLD operators

set for DC motor operation with soft start motor selection.

Reset Cycle Count

The Controller counts of the number of times the operator has been

cycled full open and close. The cycle count can be displayed. The display

will scroll the cycle count number, ﬂ ashing two digits at a time from left

to right.

To reset the Cycle Count, press and hold the ENTER button for 2 seconds

while the Cycle Count is displayed.

If the Maintenance Alert has been triggered, resetting the Cycle Count

will also reset the Maintenance Alert indicator.

Maintenance Alert Trigger

The Controller has a MAINT ALERT indicator that can be programmed

to light when the number of activations exceeds a set number of cycles.

The factory default sets the Maintenance Alert Trigger to 10,000 cycles.

The Maintenance Alert Trigger can be programmed for 5, 10, 15, or 25

thousand cycles.

The Maintenance Cycle Count can be reset independently from the

operator’s absolute Cycle Count.

FUNCTION

SET SOFT START DURATION TIME

FROM 1 TO 10 SECONDS

SOFT START DISABLED

OPTIONS

PRESS UP OR

DOWN TO CYCLE

THROUGH OPTIONS

PRESS ENTER TO

SELECT AN OPTION

SOFT START/STOP

DURATION

"SS"

DC MODELS

ONLY

FUNCTION

SETS THIS MAINTENANCE ALERT TRIGGER

FOR 5, 10, 15, OR 25 THOUSAND CYCLES

DISABLES THE MAINTENANCE ALERT

FUNCTION

RESETS THE MAINTENANCE ALERT

INDICATOR AND SETS THE MAINTENANCE

ALERT COUNT TO ZERO

OPTIONS

PRESS UP OR

DOWN TO CYCLE

THROUGH OPTIONS

PRESS ENTER TO

SELECT AN OPTION

MAINTENANCE

ALERT TRIGGER

"MA"

FUNCTION

PRESS ENTER TO START THE CYCLE COUNT DISPLAY

1ST DISPLAY

NOTE: PRESS ENTER FOR 2 SECONDS

WHILE THE "CT" FUNCTION IS DISPLAYED

TO RESET THE CYCLE COUNT TO ZERO

RESET CYCLE

COUNT

"CT"

2ND DISPLAY 3RD DISPLAY 4TH DISPLAY

EXAMPLE ABOVE SHOWS 10,420 CYCLES

DECIMAL POINT LIT

ON 4TH DISPLAY

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 37 38

Comments to this Manuals

No comments

Linear SLC User Manual Page 18

Comments to this Manuals

Related products and manuals for Safety Linear SLC