Linear BGUS User Manual download pdf (Page 5)

MODEL BGUS/BGUS-D • SG/SG-D OPERATOR INSTALLATION GUIDE

-5-

MOUNTING INSTRUCTIONS BGUS/BGUS-D•SG/SG-D

INSTALLATION ON CONCRETE CURB

1. Uncrate the gate. Avoid damaging the cabinet ﬁ nish.

2. Leave the machine bolted to the bottom pallet until ready to

install.

3. Open the cabinet door.

4. Remove the bolts holding the gate to its pallet and place the

machine in position on the curb. Refer to your Equipment Layout

(EL) drawing for proper positioning of your gate.

5. With a pencil, mark the location of the mounting holes on the

concrete.

6. Set the gate aside. Drill all four mounting holes using a 3/4”

diameter rotary hammer percussion drill bit. Insert lag screw

anchors for 1/2” lag bolts. Place the gate back in position, and

anchor it with 1/2” lag bolts and ﬂ at washers. Lubricate the

bolts before installation. Flat washers have been supplied to go

between pavement and cabinet. LINEAR highly recommends

using the corner mounting holes when mounting barrier

gates.

7. Proceed with the rest of the installation process.

1 2 3 4 5 6 7 8 9 10 ... 31 32

No comments

Linear BGUS User Manual Page 5