Linear BGUS User Manual download pdf (Page 29)

MODEL BGUS/BGUS-D • SG/SG-D OPERATOR INSTALLATION GUIDE

-29-

BATTERY MAINTENANCE

The gel-cell batteries in this operator require no routine maintenance. For assured continued performance, they should be

replaced every year.

If power is to be removed for one week or more, disconnect the negative wire from the batteries as this will prevent deep

discharging.

Fully charge before use after storage or upon initial installation.

BRUSH REPLACEMENT

Brushes should be inspected every 100,000 cycles, (200,000 for BGU-D)

or yearly, whichever comes ﬁ rst. The motor has two brushes, one on each

side.

Original brushes are approximately 3/4” long and should be replaced when

they are 1/4” long, or sooner. If brushes are allowed to wear beyond this point,

permanent damage to the motor may result.

To inspect the brushes, remove retaining cap (A), with straight-blade

screwdriver, and carefully pull assembly straight out. Measure remaining

brush material (B).

To reinstall, place brush in hold, aligning rounded indentation (C), correctly

with motor shaft. Gently push in spring and align contact with oval carrier,

push in with retaining cap (D). Hold in place and thread cap into brush carrier.

Do not overtighten or cap will crack! Repeat for other brush.

If brushes require replacement, order kit #2510-243.

1 2 ... 24 25 26 27 28 29 30 31 32

No comments

Linear BGUS User Manual Page 29